中 文
English
technical support
Product Recommend

Sunning small wind turbine problem shooting

Update Time:2014-08-18 11:01:48 Writer:Sunning Source:Sunning

1.jpg

Sunning small wind turbine problem shooting(built-in MPPT controller)
Step one--Preparation
One multimeter
Step two--Testing
1.adjust the multimeter to the Voltage(V)
2.connect the positive pole (+) and negative pole (-) of multimeter to the wind turbine positive pole and negative pole as following

2.jpg
When the wind turbine is moving,the multimeter shows data,it means the wind turbine is workable.
If there is no data on the multimeter, it means that there is some problem of wind turbine.

3.jpg
4.jpg
Reason one, maybe the flange stuck the cable, and make the system works abnormality.
Reason two, there is some defects of the wind turbine(at this case, the wind turbine need to return to depot)

Sunning small wind turbine problem shooting(without built-in controller)
Step one--Preparation
One multimeter
5.jpg
Step two--Testing

Method one
adjust the multimeter to the Diode, connect the positive pole (+) and negative pole (-) of multimeter connect to any two wires from wind turbine as following, if it is breakover, the multimeter will alarm, if not, there is not alarm, it means that there is the wind turbine is workable.
Method two
adjust the multimeter to the Voltage(V),connect the positive pole (+) and negative pole (-) of multimeter connect to any two wires from wind turbine as following,and move the wind turbine, if there is data shown on the multimeter, it means the wind turbine is working.
6.jpg

More: www.sunningwind.com

 

更多